Crater Maker Dimple Die - 1/4" gappers

Crater Maker Dimple Die - 1/4" gappersThis is the best quality made in the USA dimple die available. Need to add a little bit of detail to your work? Drill or punch a 1 4 hole where you would like this detail then use either an impact hammer (air or cordless) or a hydraulic press to drive these dies together and form a unique "Crater" in your panel. These dimple dies are made from 4140 alloy steel and then hardened and tumbled for a smooth finish. Dimensions are 1. 5" diameter by

These C10 tees are made from 100% cotton lightweight Anvil T shirts

light cutting on tailgate and rear bed sill

and cerakote black stainless

This is normal and you should plan on using a flanged bolt or a washer with your fastener

preshrunk 100% combed ringspun cotton

Correct geometry for modern wheel fitment

weld them into place

replacing the outdated gearbox with a modern Detroit Speed rack and pinion system

they're gone for good

Comes with 1/4-20 mandrel and hard plastic case

The tool trays have stops that bolt onto the back with PEM inserts so your tools don't fall into the abyss

and 20” lengths — designed for body and paint professionals who demand a straighter cut and tighter surface control