PrintDry Filament Dryer PRO3 titanium "What will you make

"What will you make

Use the 3D Printer Compatibility Chart below to determine which Bimetallic Heat Break™ is best suited for your application

The PTFE liner in Lite6 means that there is a temperature limit of 240C

and RV industries and for exterior applications such as mirror housings

PrintDry Filament Dryer PRO3 titanium "What will you makeEasily adjust the temperature with 6 presets (35C, 45C, 55C, 65C, 75C, and 85C). Built in timer with a maximum time of 48 hours. Note: The temperature readings are directly measured at the tip of the temperature sensor, located about 15 mm away from the hot air vent. The temperature distribution inside the dryer is NOT uniform. The temperature in a place close to the hot air vent is higher and the temperature in a place far away from the hot air vent