3D Printed Red Sea ReefWave 25 Flow reducer Color:Black

3D Printed Red Sea ReefWave 25 Flow reducer Color:BlackSet of two flow reducers for the Red Sea ReefWave 25 gyre pump. Adjustable flow reduction to allow the use of these gyre pumps in a smaller nano size tank. These clip over the stock guards and reduce amount of water flowing through the pump depending on the orientation of the stock guard in relation to the flow restrictors. The guards also have adjustable output direction, upward, horizontal, downward. Please note these are not anemone guards! Printed

Simple to install and no risk of your tank inhabitants getting sucked in through the back of the pump

or 1/4 of a Nori sheet

There is a little notch on the guard to catch the hook on the pump face

Will fit either Model 1000 or 2000

No metal parts to rust and corrode

The arm holding the hose has a slight downward angle to minimize water splashing out of the bucket while inserting the hose into the holder if the syphon is flowing

This is a one piece item

Silver white center around the mouth with silvery white tips on the long flowing tentacles

Red or Blue ABS with black nylon screws

WYSIWYG #1 - 2 large polyps and two small polyps growing

Hole Sizes:

Simply remove the original and replace with this one