Characterisation of waste. Compliance leaching test. One stage batch leaching test for monoliths at fixed liquid to surface area ratio (L/A) for test portions with fixed minimum dimensions Ingestion-build-93833

Characterisation of waste. Compliance leaching test. One stage batch leaching test for monoliths at fixed liquid to surface area ratio (L/A) for test portions with fixed minimum dimensions Ingestion-build-938331 Scope This Technical Specification specifies a compliance test for routine testing providing information on the leaching of monolithic waste which can be obtained under the experimental conditions specified hereafter with a single batch leaching test at a specified liquid to surface area ratio (L A) of 12 (cm3cm 2). It applies to test portion of monolithic waste of regular shape, with a minimum dimension of 40 mm in all directions, obtained e. g. by

This document does not apply to diving equipment and to positive pressure demand breathing apparatus

- a seal status identification system

Direct contacts between telecommunication lines and low voltage power lines

the applied impulse should be synchronized with the activity of the integrated circuit to make sure that controlled and reproducible conditions can be assured

natural gas and LPG respectively)

ensuring operational safety and performance in agricultural and forestry applications

opening information and sharing data on vendors

special means against water vapour diffusion and water accumulation by air flow might be required

1 Characteristics from tensile test

This standard is applicable to primary devices having an orifice plate used with flange pressure tappings

Consequently a European market participant (TSO

Optical paths consisting of optical fibres and optical waveguides