Hydraulic fluid power. Cylinders. Housing dimensions for rectangular-section-cut bearing rings for pistons and rods Ingestion-build-93833

Hydraulic fluid power. Cylinders. Housing dimensions for rectangular-section-cut bearing rings for pistons and rods Ingestion-build-938331 Scope This International Standard specifies the preferred range of nominal dimensions and associated tolerances for a series of hydraulic cylinder piston and rod housings for rectangular section cut bearing rings, of the type shown in Clause 5, for applications in the following range of dimensions: for cylinders with bores of 16 mm to 500 mm, inclusive; for rods with diameters of 12 mm to 450 mm, inclusive. This International Standard does not give

Manufacture or supplier of steel products

Some specific analytical terms used in the relevant International Standards are also included

Note: BS EN ISO 17636 does not specify acceptance levels for any of the indications found on the radiographs

including BS EN ISO 14064-1 on greenhouse gas inventories and BS EN ISO 14044 on lifecycle assessment

including country

ISO 5577 serves the purpose of defining the terminology for various aspects relevant to non-destructive

Requirements for the marking of equipment and the information to be supplied by the manufacturer are given

PD IEC TR 63139 provides details on the insulation between LV supply and control line conductors

Laboratory tests

• Spectral attenuation loss (according to EN 61300-3-5)

BS ISO 2846-4:2000 Graphic technology

pre-service and for in-service inspection