Measurement of fluid flow in closed conduits. Flowrate measurement by means of vortex shedding flowmeters inserted in circular cross-section conduits running full Ingestion-build-134498

Measurement of fluid flow in closed conduits. Flowrate measurement by means of vortex shedding flowmeters inserted in circular cross-section conduits running full Ingestion-build-1344981 Scope This document a) describes the use of vortex shedding flow meters for liquids, gases, and steam, including a glossary and a set of engineering equations used for specifying performance, b) provides technical information to assist the user in selecting, specifying and applying vortex shedding flowmeters, including influence effects, c) describes typical construction and provides recommendations for inspection, certification, and material

PD CLC/TR 50646 on specifications for reversible D

Organizations that design and maintain acme screw threads

DD IEC/TS 61850-80-1 is a technical specification which gives guidelines on how to exchange information from a CDC based data model (for example IEC 61850) using IEC 60870-5-101 or IEC 60870-5-104 between substation(s) and control center(s)

The requirements cover non-connectorized single-mode fibre optic pigtailed isolators for category O used in an uncontrolled environment and a sequential test

An optional longitudinal groove for locking purposes

— access gangways when used as a lifting appliance

a) a dedicated development life-cycle addressing each phase of the development of HPDs

BS EN 61965 on Mechanical safety of cathode ray tubes is useful for:

This European Standard defines terms and specifies the general design characteristics of mobile ladders with platform

The C connector is a type of RF connector used for terminating coaxial cable

by helping you measure the speed fluctuations in sound recording and reproducing equipment BS 4847 helps you enhance their sound quality

BS 6083-10 on hearing aids is relevant to: