Hydraulic fluid power. Dimensions and identification code for mounting flanges and shaft ends of displacement pumps and motors - Inch series shown in metric units Ingestion-build-82061 The diameter of the spread

The diameter of the spread mixture is measured after a specified time

9 As-built information

applications and the essential requirements and are further illustrated with detailed diagrams and tables

Note: The calibration of fibre coating or cable measurement test sets is not covered by BS EN 61745

Hydraulic fluid power. Dimensions and identification code for mounting flanges and shaft ends of displacement pumps and motors - Inch series shown in metric units Ingestion-build-82061 The diameter of the spread1 Scope This part of ISO 3019 specifies sizes and dimensions and establishes an identification code for the two and four bolt mounting flanges and the shaft ends of positive displacement, rotary hydraulic fluid power pumps and motors. It is applicable to cylindrical keyed shaft ends with an external thread, as well as to those without a thread, to conical keyed shaft ends with an external thread and to 30 involute spline shaft ends. NOTE Involute