Sanitary tapware. Pressure flushing valves and automatic closing urinal valves PN 10 Ingestion-build-79769

Sanitary tapware. Pressure flushing valves and automatic closing urinal valves PN 10 Ingestion-build-797691 Scope This draft European standard applies to flushing valves for WCs and valves for urinals, with automatic hydraulic closure, intended for : WC pans EN 997 ; single flush urinals prEN 13407 ; siphon acting urinals prEN 13407. It does not apply to no contact detection valves. It is intended to specify : marking and identification, physico chemical, dimensional, leaktightness, pressure behaviour, hydraulic, mechanical endurance and acoustic

It supplies UK-centric advice on using the test methods for asphalt given in the multi-part European standard series BS EN 12697

— basic overview about fundamental concepts of IEC 61360

The m/z values (mass/charge ratios) for quantification and identification

BS EN 13411-1 specifies the minimum requirements for non welded general purpose steel thimbles produced from plates having dimensions by Figure 1

The provisions of this specification are not restricted to fishplates for use with rails that comply with BS 11 and may be applied to fishplates for any rail section of 24

This part of ISO 9949 defines terms used in the field of urine absorbing aids and comprises the vocabulary for conditions of urinary incontinence

critical success factors and values through improved internal communication and knowledge

This Technical Report specifies the procedure on how to evaluate and treat the most commonly found manufacturing imperfections on seamless steel and aluminium alloy gas cylinders at visual inspection at the stage of product acceptance

Why should you use BS EN 60077-2 – General rules for electrotechnical components in rolling stock

and 1 550 nm

and in particular

fibre optic cables offer the ideal solution for data transmission in these areas