Standard Guide for Additive Manufacturing. General Principles. Requirements for Purchased AM Parts Ingestion-build-264231

Standard Guide for Additive Manufacturing. General Principles. Requirements for Purchased AM Parts Ingestion-build-264231

A rating scheme for pressure marking

Note: This method is not suitable for the determination of the density or relative density of highly volatile liquids having Reid vapour pressures greater than 50 kPa according to ISO 3007 or having an initial boiling point below 40 °C

Clause 9 final tests updated

This European Standard consists of guidance and recommendations and is not intended to be used for certification

BS EN 60079-17 is a part of an international multi-series standard that focuses on safety aspects for explosive atmospheres

This International Standard specifies an electrogravimetric method for the determination of the mass fraction of copper in copper sulfide concentrates in the range 15 % to 50 %

a GBR-C with a polymeric or bituminous geosynthetic barrier attached to it) when used as fluid barriers and separation layer in the construction of underground structures (other than tunnels and associated structures)

describes a method for the assessment of the containment efficiency of general purpose laboratory fume cupboards

and satisfying real needs

Detailed technical requirements checklist

BS EN 61188-5-3 provides information on land pattern geometries used for the surface attachment of electronic components with gull-wing leads on two sides

BS EN 15860 on thermoplastic semi-finished products for machining is useful for: