Planted Seat Bracket For Ford Mustang (1979-1998) - Passenger Cadenza

Planted Seat Bracket For Ford Mustang (1979-1998) - Passenger CadenzaWe do not maintain inventory count for Planted brackets. If it is in stock from Planted website, it will be shipped within 1 2 days. If not, expect a 7 10 days build time+shipping time. The Planted Seat Bracket is a vehicle specific bracket used as an adapter between the floor of the vehicle and an aftermarket seat and it's accessories. Because the floor of each vehicle varies and typically is not flat, a vehicle specific Seat Bracket is required for

This actuator is set at 5 psi

Cast iron T3 manifold

- 100% stainless steel with 4" titanium blue finish tip

Right rotor (disc & bell assembled)

Damping Levels 32 Levels Height Adjustment Yes Spring Rate(Front) 7 kg/mm (392 lbs/inch) Spring Rate(Rear) 5 kg/mm (280 lbs/inch) Spring Length(Front) 180 mm Spring Length(Rear) 200 mm Camber Plate(Front) Yes Camber Plate(Rear) No Spring Inner Diameter(Front) 62 mm (2

Front Diameter 25

They replace the OEM Tie Rod Ends with a high strength steel alloy Tie Rod End that can be used to fine tune Toe-Adjustments and by proper use of spacer combination can be set to proper suspension geometry to achieve the most steering angle possible which is crucial for drifting and other motor-sports

5" Pipping (2

2000 RPM: 97 db

13-20 RWD/AWD

Spring rates: Front: 8 kg/mm / Rear: 5

Part #: LSDN-00 (LS-D03)